Search the Community
Showing results for tags 'minipin'.
Found 2 results
Edited to include all content in first post I have lurked for a while... now I am building. I decided to go the mini-pin route. I am pulling from every post I've read but especially from deegor and swaffar(for design and electronics) Thanks to all, and here we go. Specs: I5 OC Win7 32bit 4gb RAM GTX660 19"(4:3) 27" (16:9) 7"(mimo) 7 24v contactors 24 power supply 12v power supply ipac ledwiz speakers and 12v amp knocker 5 RGB LEDs 3 tilt mercury switches Here is a comparison of full size to mini... The hardest bit so far was routing this out Got XP all set up Backbox Main cab Adding a slide out to give me some more room to work with Found some legs off of an old cabinet Super tight fit! 24v and 12v power supplies another shelf... need more room! This is the artwork I have modified.... Thanks to STUZZA So that is where I am at right now. Next step wiring. I have a little finished. Resistors arrived.... finished wiring and testing my "feedback board" [ATTACH=CONFIG]42079[/ATTACH] I also added a power button to the back. [ATTACH=CONFIG]42080[/ATTACH] Wiring is complete! It was hard to keep every neat enough to be able to still service it if needed. I used longer wires so that if needed I would be able to pull the feedback shelf up and back to get to the stuff below. [ATTACH=CONFIG]42094[/ATTACH] Here it is seated back down. [ATTACH=CONFIG]42095[/ATTACH] added a credit button since I am not doing a door. [ATTACH=CONFIG]42096[/ATTACH] I have it wired up for 5 LEDs but right now am going to just use the 3 at the back of the playfield(may add the extra two on top of the back box). I also have about 5 extra outputs which may turn into RGB flippers, in any case should be a pretty easy add since most of the stuff is there already. Waiting on fuses... C'MON CHINA!!!!!! Got my glass on. I added some labels to my buttons, popped the top and used some printed out words. They look great and shouldn't be a fire hazard since they are LEDs... but we'll see how they hold up. Got the last two lights wired in.... much better now. Got my art(Lucian) and got it applied. Got my mercury switches today.... Installed 3 and they work pretty darn good. I will need to fiddle with them to get the angle right but for the most part they work as planned. I finally got my lockdown bar Gameplay video: