nguerra Posted March 24, 2015 Posted March 24, 2015 Never had this issue before but I recently copied everything over to a new hard drive. When I'm in Hyperspin, I can select a game and launch it just fine. The screen goes black for 2 seconds and then goes back to the hyperspin menu. Oddly enough the emulator did launch because I can do an Alt-Tab to select it. Once I bring the emulator back to the front, I get a black screen for 2 seconds and then the game starts and plays just fine. Hitting escape brings me back to hyperspin just like it's supposed to. This only seems to happen with two emulators, BlueMSX for Colecovision and Nestopia for NES. Seems like a timing issue but I'm not sure what or where, any ideas?
nguerra Posted March 24, 2015 Author Posted March 24, 2015 Just noticed that this only happens when I run hyperspin in full screen mode. Still not sure why.
OneLgGrsy Posted March 25, 2015 Posted March 25, 2015 Had never seen that before... was in the middle of a new install and was searching the forums to try to fix my issues and saw your post last night. Funny enough, today it happened to me. I have been working with 2 monitors while setting up (eventually to switch to a single TV). I am getting down to finishing the setup and unplugged one of the monitors (which is when I saw the issue you bring up). I went in the display selection and it was still showing the 2nd monitor (even though it was unplugged). I just had the machine detect the monitors again and then it worked fine. Not sure this applies to you, but it was just funny to me that I saw you had this issue last night and all of a sudden it happened to me today.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.