Jump to content

  • QUESTION : Is the new Hyperspin and HyperHQ Arcade cabinet ready?

    Marcoqwerty

    By Marcoqwerty

     Share

    A lot of compliments for the new beta build of Hyperspin super exited to try out in my arcade cab.

    But this is my question.

    Is this new version ready for a low res 4:3 arcade monitor? or its just made for Pc desktop ?

    Sorry if this question was already placed, but i would like to test in my arcade intallation and i would like to be sure about that.

    Also i have few other extra question.

    1) what are the minimum requirements to run?

    2) it work with the last Switchres and Groovimame?

    I could test my setup but better ask in advance to avoid trouble.

     Share
    Go to records

    User Feedback

    Recommended Comments

    rondar

    rondar 684

    Posted

    It will support 4:3, but it’s not the main objective for this early beta.

    The themebuilder allows 4:3, and it will require you to do a little moving around to make it work. (All themes that are being built right now are widescreen)

    An official “minimum requirements” has not been established yet but I’m using a pretty average pc from about 4 years ago and haven’t run into any performance issues. 

    I don’t use them, so unsure about switchres and groovimame 

    • Like 1
    Marcoqwerty

    Marcoqwerty 109

    Posted

     

    21 hours ago, rondar said:

    It will support 4:3, but it’s not the main objective for this early beta.

    The themebuilder allows 4:3, and it will require you to do a little moving around to make it work. (All themes that are being built right now are widescreen)

    An official “minimum requirements” has not been established yet but I’m using a pretty average pc from about 4 years ago and haven’t run into any performance issues. 

    I don’t use them, so unsure about switchres and groovimame 

    Thank you soo much.

    My worst nightmare is not the theme creation but the GUI that is impossible to show in the low res screen mode, this made impossible to install and configure Hyperspin in any arcade cab.

    Please...if its possible, add a extra visualization of the Hyperspin GUI for low res system, Rochetlauncher made a good guy suitable for both side (if you need some direction)

    Thank you a lot for your work!!! 


×
×
  • Create New...