Xpadder problem

[omarus]

Hi everyone!

I have some issues with xpadder in hyperspin and I really need your help

Here is my system and my software for Hyperspin

64-bit Windows 7

Hyperspin v 1.3.2

RocketLauncher.0

Xpadder v.5.7

pad : Logitech F710

I have read a lot of tutorials here and there and I was able to configure everything and almost all emulators works fine without problem ; But when I want to control everything with Xpadder I have a little problem I can not solve :

Once all profiles configured on Xpadder hyperlaunchHQ ( Hyperspin , hyperlaunch , emulators ), I run hyperspin the xpadder profile load and works fine but when I decide to load an emulator there is no possibility to switch from Hyperspin profile to that emulator profile: I get the following message: "An error has occured Error: . . ! AutoProfileScan failed to stop shoulds This error never happen visit the official website , etc ... "

When I use the version 5.3 of Xpadder , it works fine, the profiles loads for all the emulators and get back without problem to hyperspin profile when i exit them. The problem is I get that annoying message of the UAC : " Do you want to allow the following program from an unknown publisher to make changes to this computer" each time i switch from hyperspin to the emulator; and of course I don't want to disable the UAC for security reasons ...

What should I do to solve my problem?

Thanks in advance for your help ...

[ghutch92]

Get a newer version of xpadder. Some things were changed in the command line in 2012. RocketLauncher interacts with xpadder through the command line options, so updating is important. Also did you know that the program files folders were write protected? Meaning a UAC prompt anytime you try to write to them.

[omarus]

Thanks! works fine now...