keithpaw Posted January 5, 2015 Share Posted January 5, 2015 Hi all, My Hyperpin table is now very close to being complete it has took me many months off and on with work and family commitments. I have just installed my LED-wiz board and the four RGB buttons I have connected work great. However how would I connect my launch ball lamp so it can be programmed for flashing when ball is on the ramp to be fired. If anyone could point me in the right direction that would be great. I have my Vishay fully wired plug and play DMD arriving this week so advice on software installation would also be very welcome. thanks. Link to comment Share on other sites More sharing options...
keithpaw Posted January 6, 2015 Author Share Posted January 6, 2015 Please could someone point me in the right direction it may be a silly question but im not sure how the launch button interacts with vp i presume that it has to go through the LED-WIZ are there any tutorials out there as I have been searching forums for hours. thanks Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.