Jump to content

acott

User
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About acott

  • Rank
    HyperNewbie
  • Birthday 08/20/1986
  1. Cheers Gerurver, I went against the advice of most people, I didn't prime the MDF, I didn't heat treat, I didn't make it wet...I just peeled it off and stuck it on Although I do advise you to have someone on hand to help, I had to toss some in the bin as it got stuck to itself..or me! The corners aren't much of a problem, most of them are going to be hidden when everything is put together. I was careful with how I cut and wrapped around, I can take a snap for you if you like? The finish is Matt, but you can go glossy. I wrapped the whole thing for under €20, I wrapped the sides and control panel even though I intend on putting art on them so you could possible do it for less. I have designed the art, but the dimensions are wrong. I think I can roughly work out the size now. Heres how the art should look :
  2. BUMP! Sorry to bring this up again, I'm just anxious to get the template so I can finish off the cabinet. So far I have it wrapped in vinyl and put the t moulding on, its been sitting like this for almost a year as I haven't had the time to finish it but this time I'm determined! I believe the template looks something along the lines of this but I cant find the large file
  3. Hopefully I'm posting this in the right thread. I purchased a 2 player flatpack bartop arcade cabinet on ebay from Rich's Bartop ( Image below ) I got this over a year ago and I'm only getting around to finally finishing it off I asked Rich if he had a blank template/psd for the artwork, he said he didn't, but someone had uploaded a template to this forum. I've been searching through all the posts but cant seem to find the template, would anyone happen to have the template or could they possibly point me in the right direction? Any help would be much appreciated. Cheers!
  4. Cheers for this mikekim I think I have a better understanding!
  5. Hey Mikekim, I've learned a lot from following this thread thanks very much. Finally I've purchased a kit from ebay which is very similar to yours and have started assembling. Just one quick question, how exactly did you mount your perspex/glass? I've been trying to figure it out by studying your photos but can't seem to work it out! BTW I also purchased a Dremel to fit my T-Molding, thanks for the tip!
×
×
  • Create New...