Jump to content

steveweener

User
  • Content Count

    6
  • Joined

  • Last visited

Community Reputation

1 Neutral

About steveweener

  • Rank
    HyperNewbie
  • Birthday 01/25/1985

Profile Information

  • Gender
    Male
  • Location
    UK

Converted

  • Location
    Leeds, England
  1. Yeah, using jpeg's will definitely reduce your file size compared to .png. If you're using Photoshop, you can also set the jpeg quality when saving it out, obviously lower the quality the smaller the file size. Also, check the dimensions of your jpeg's aren't too big. I would give that a try
  2. Figured it out now: Turns out I hadn't configured 'Profile1' correctly for joytokey when it starts up. Feel a bit silly, but happy it's sorted Cheers anyway!
  3. Hi guys, I'm looking for a bit of help, I've searched the forums but can't find an answer, so here goes: Basically my machine is all set up and ready to go. All my Joystick/button presses have been mapped successfully using joytokey and work in Mame as well as browsing through Hyperspin then launching/playing a game, however I have one problem that's holding me up. When I launch Hyperspin, my joytokey profile doesn't automatically load itself. This means I have to manually go into HyperLaunchHQ, click on my joytokey profile then hit 'edit' for it to run the profile, and then start Hyperspin for it to recognize the joysticks/button presses from start up. I've tried going into HyperHQ and setting the startup program to run joytokey.exe, however this doesn't work. I've followed this guide, and been through it a few times now with no luck: http://gameroomsolutions.com/hyperspin-controller-setup-with-joytokey-and-gamepad/ Since encountering this problem I've been specifically concentrating on the 'Important for getting it to Launch' section near the end, maybe I've missed something? I wondered if it might have something to do with my Hyperspin route directory being set to Read Only, however when I uncheck Read Only, then check back at the folder properties it's set back to Read Only even though I am administrator....could it be something to do with that? It does seem to be doing something when I uncheck it though.... Any help would be much appreciated so I can get finished
×
×
  • Create New...