arcadepcnut Posted August 4, 2015 Share Posted August 4, 2015 Hello all. Got everything ready to convert my virtual pin to LEDs and feedback with contactors. Also read the pinball 101 document and sorta have a handle on things. But I've got a few questions, I have a 12v supply for the LEDs. And a 24v supply for my 7 contactors and my knocker. The contactors I understand can run directly off the ledwiz and no need for a relay? My main question is how to wire the knocker. The knocker I know for sure I need a relay. I'm using the standard car relays. 87 87a 30 86 85 I'm just not sure how to wire it! It has the pins 30 which I think goes to my 24v power supply directly. 85 goes to ground. Here is the part I don't know. Does 87 or 87a go to the knocker? And 86 is my trigger from the ledwiz? Please help and offer some pointers. Will my 24v contactors need relays? I read they can just go one pin ground and the other 24v through the ledwiz so there is no lag. Wiring The relays confuse me. Link to comment Share on other sites More sharing options...
HazzardActual Posted August 4, 2015 Share Posted August 4, 2015 Might get a better response if you post this in the HyperPin boards Link to comment Share on other sites More sharing options...
arcadepcnut Posted August 4, 2015 Author Share Posted August 4, 2015 Might get a better response if you post this in the HyperPin boardsGood point. Thought I did. Thanks for pointing that out. So used to going to this forum for help with my Hyperpin cabinets!! Haha Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.